Pages: 1 [2]
« previous next »
Author Topic: Adding braze-ons...  (Read 3422 times)
kp
Member
SUpeR MOLTEn LavA Bicyz
*****

Karma: +30/-6
Posts: 827



View Profile WWW
« Reply #15 on: October 21, 2008, 12:58:25 PM »
I will order rack and canti bosses along with flux and silver when Henry James reopens end of the week. Bosses are inexpensive, so Art and Elizabeth, you can piggy back on my order and pay for those items later. Obviously there's no charge for brazing as it is going to be a refresher course for me and learning experience for all of us. Yes, a brazing party!

Art, any ideas on jerry-rigging a canti boss jig? Sheldon (RIP) has a picture of his homemade. Anvil's cost about $350.
Logged

kp
Member
SUpeR MOLTEn LavA Bicyz
*****

Karma: +30/-6
Posts: 827



View Profile WWW
« Reply #16 on: November 02, 2008, 05:51:03 PM »
I think it came out ok. Those rack bosses were re-brazed on as they were initially put on crookedly. Those of you who can read heat signatures on steel might be able to give me a feedback.

* rack bosses_02s.jpg (141.74 KB, 800x600 - viewed 123 times.)
Logged

kp
Member
SUpeR MOLTEn LavA Bicyz
*****

Karma: +30/-6
Posts: 827



View Profile WWW
« Reply #17 on: November 03, 2008, 08:25:21 PM »
Elizabeth.

I am good for this thursday 10am. Call or e-mail me for directions. I am in Mar Vista.

Art & JB, if you are still interested in joining the party, contact me.
Logged

Pages: 1 [2]
Print
« previous next »
 
Jump to: